- R & D Started
in 1992.
- Completed in 2000.
- Test Launch in
2001.
- Modifications in
2001.
- Tested, certified
and approved by ETDC, Dept of Electronics, Govt. of India in 2001.
- Got Patented and
trade mark in 2001.
- All India Launch
in 2002.
- Export Operation
started in 2002.
- Again got tested
and certified by prestigious bodies such as EQDC, ERDA, SSIDC etc.
- ENSAVE basically
works on the principle of 'On line monitoring and controlling of power
factor' of load. This on line monitoring of PF is done by our unique
software and as per the demand of load it improves the PF.
- ENSAVE improves
the load power factor up to 0.999 and reduces the reactive component
of total power used by instrument/ load.
- This reduces the
current drawn by load and ultimately reduces total wattage consumption
up to 15% to 35% and thus gives saving in energy.
- ENSAVE' also acts
as a home protector.
- 'ENSAVE' cuts down
the acute over voltage (above 280Vac) or under-voltage (below 160Vac)
Supply in fraction of seconds and it also automatically starts the supply,
when supply becomes normal.
HOW TO INSTALL ENSAVE?
- 'ENSAVE' is always
installed between energy meter and load.
- Load may be inductive
or resistive or combination of both.
- The outgoing phase
and neutral from energy meter are connected to the respective P1 for
phase and N1 for neutral given in ENSAVE.
- Output of 'ENSAVE'
i.e. P2 and N2 are connected to the load.
|